Table of Contents
Advertisement
es
CHAPTER 1 GENERAL INTRODUCTION
ml
3)
Remove the new ink bottle from its package
=
6)
Putthe ink cap on the ink cap stand.
and remove the ink cap.
4)
Insert the air vent tool into the ink bottle as
shown in Figure 1-307.
Figure 1-309
7) Set the new bubble jet cartridge. (Refer to the
D. bubble jet cartridge replacement procedure).
Figure 1-307
Note:
Remove the ink bottle as little as possible,
5)
Set the ink bottle in the ink bottle case.
except in the case of replacing it, other-
wise the ink at the buffer section might
run over.
Figure 1-308
Advertisement
Table of Contents
