Table of Contents
Advertisement
4)
Remove two mounting screws, and protection
sheet.
Screw
Figure 5-221
5) Remove mounting screw, and remove the vol-
ume cover while moving tubes.
6)
Remove mounting screw, and remove the vol-
ume cover while moving tubes.
Volume Cover
Screw
Figure 5-222
COPYRIGHT © 1998 CANGN INC.
Protection sheet
CHAPTER 5 TROUBLESHOOTING
ml
7)
Fix the long flexible cable, flexible mylar and
tubes using tape.
Tape
Figure 5-223
8)
Insert the cover switch jig.
Cover switch jig
Figure 5-224
9) Set the printer to the service mode, and select
"Sensor Light Adj."
(Refer to page 5-43 about Service Mode
descrivibing below)
Sensor
Light
Ad j
No
Advertisement
Table of Contents
