Table of Contents
Advertisement
[INTERNAL]
[FULL]
5)
Press as to select [INTERLOCKED].
6)
Press qw to switch the item.
[OFF]
[ON]
7)
Press as to select [VERTICAL] or [HORIZONTAL].
f If [ON] is selected, select [BOTH].
8)
Press qw to adjust.
Note
f When the [POSITION] menu → [ASPECT] is set to anything other than [DEFAULT], [MODE] is not displayed.
f [ZOOM] cannot be adjusted when the image of 1080/120p or 1920 x 1080/240 is projected.
f [ZOOM] cannot be adjusted when YP
<DIGITAL LINK/LAN> terminal.
[CLOCK PHASE]
You can adjust the image to achieve an optimal image when there is a flickering image or smeared outlines.
1)
Press as to select [CLOCK PHASE].
2)
Press qw or the <ENTER> button.
f The [CLOCK PHASE] individual adjustment screen is displayed.
3)
Press qw to adjust.
f Adjustment value will change between [0] and [+31]. Adjust the image so that the amount of interference is
at a minimum.
Note
f Adjustment may not be possible depending on the signal.
f There may be no optimal value if the output from the input computer is unstable.
f There may be no optimal value when the total dot number is shifted.
f [CLOCK PHASE] can be adjusted when YC
f [CLOCK PHASE] cannot be adjusted when a digital signal is input.
f The adjustment value will change to [0] when w is pressed while it was at [+31]. Also, the adjustment value will change to [+31] when q is
pressed while it was at [0].
[GEOMETRY]
You can correct various types of distortion in a projected image.
Unique image processing technology enables projection of a square image on a special screen shape.
The projected image can be made to look more natural by making topical correction as necessary.
1)
Press as to select [GEOMETRY].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[KEYSTONE]
[CORNER CORRECTION]
[CURVED CORRECTION]
Note
f The menu, logo, or waveform monitor display may run off the screen when [GEOMETRY] is set.
f The edge blending adjustment may not be performed correctly depending on the environment when using the [ADVANCED MENU] menu →
[EDGE BLENDING] and [GEOMETRY] simultaneously.
f The image may disappear for a moment or may be disrupted while performing adjustment, but it is not a malfunction.
f When [GEOMETRY] is used, the image may not be displayed correctly if adjustment increases.
78 - ENGLISH
Chapter 4 Settings — [POSITION] menu
Enlarges the size within the aspect range set with [SCREEN FORMAT].
Enlarges or reduces the size using the entire display area set with [SCREEN FORMAT].
Sets the [VERTICAL] and [HORIZONTAL] zoom ratio.
Uses [BOTH] to set zoom ratio. Image can be enlarged or reduced vertically and horizontally at the
same magnification.
P
/YC
C
signal of 4:2:0 format is input to the <HDMI IN 1> terminal, <HDMI IN 2> terminal or
B
R
B
R
C
/YP
P
signal or analog RGB signal is input to the <COMPUTER IN> terminal.
B
R
B
R
Does not perform geometric adjustment.
Adjusts any trapezoidal distortion in the projected image.
Adjusts any distortion in the four corners of the projected image.
Adjusts any curved distortion in the projected image.
Advertisement
Table of Contents
