Panasonic PT-FRQ60WU7 Operating Instructions Manual page 191

Update in standby mode
Rewriting of the firmware can be performed by operating the buttons on the control panel even if the projector is in
the standby mode.
Set the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] to [NORMAL] in advance.
If [ECO] is set, the firmware cannot be updated in standby mode.
1) Insert the USB memory with the firmware data saved into the <USB (DC OUT)> terminal of the
projector.
2) Confirm that the projector is in the standby mode.
3) Press in order of aass on the control panel, and press the <ENTER> button.
f The projector will go into the update ready state.
f Once the projector goes into the update ready state, the power indicator <ON (G)/STANDBY (R)> will turn
off, and the light source indicator <LIGHT> and the temperature indicator <TEMP> will light up in red.
4) Enter the security password and press the <ENTER> button.
f Update is started.
f Once the update is started, the power indicator <ON (G)/STANDBY (R)> will light up in red, and the light
source indicator <LIGHT> and the temperature indicator <TEMP> will blink in red alternately.
f Update is completed when the light source indicator <LIGHT> and the temperature indicator <TEMP> stop
blinking and turn off.
Attention
f Do not disconnect the main power supply of the projector while updating.
Note
f The security password is the password set in the [SECURITY] menu → [SECURITY PASSWORD CHANGE].
Initial password of the factory default setting: awsqawsq
f In following cases, turn the power of the projector off and on and perform the update from the beginning.
g When the update does not complete after 60 minutes or more have elapsed
g When the power of the projector has turned off due to power outage, etc., during the update
f If the security password is not entered for approximately 60 seconds in the update ready state, the update ready state will be canceled and
the projector will go into standby mode.
Chapter 5 Operations — Updating the firmware
ENGLISH - 191