Table of Contents
Advertisement
<HDMI IN 1> terminal
<HDMI IN 2> terminal
<DIGITAL LINK/LAN>
terminal
<LAN> terminal
<COMPUTER IN>
terminal
Connecting
terminals
<MONITOR OUT>
terminal
<AUDIO IN> terminal
<AUDIO OUT> terminal M3 stereo mini jack x 1, 0 V [rms] to 2.0 V [rms] (variable), output impedance 2.2 kΩ or lower
<SERIAL IN> terminal
<USB (DC OUT)>
terminal
Acoustic noise
*1
Operating temperature
Operating
environment
Operating humidity
Operation position
*1 Measurement, measuring conditions, and method of notation all comply with ISO/IEC 21118:2020 international standards.
*2 The operating environment temperature should be between 0 °C (32 °F) and 40 °C (104 °F) if the projector is used at an altitude between 1 400 m
(4 593') and 4 200 m (13 780') above sea level. When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [OPERATING MODE] is set
to [ECO] or [QUIET], the projector cannot be used at an altitude of 2 700 m (8 858') or higher above sea level.
*3 The operating environment temperature should be between 0 °C (32 °F) and 40 °C (104 °F) when the optional Wireless Module (Model No.:
AJ-WM50 Series) is attached.
*4 When the operating environment temperature exceeds the following value, the light output may be reduced to protect the projector.
f When using the projector at an altitude lower than 1 400 m (4 593') above sea level:
g PT-FRQ50: 33 °C (91 °F)
g PT-FRQ60: 31 °C (88 °F)
f When using the projector at an altitude between 1 400 m (4 593') and 2 700 m (8 858') above sea level:
g PT-FRQ50: 29 °C (84 °F)
g PT-FRQ60: 27 °C (81 °F)
f When using the projector at an altitude between 2 700 m (8 858') and 4 200 m (13 780') above sea level: 25 °C (77 °F)
212 - ENGLISH
Chapter 7 Appendix — Specifications
HDMI x 2, HDCP 2.3 compatible, Deep Color compatible
Audio signal
Linear PCM (sampling frequency: 48 kHz/44.1 kHz/32 kHz)
RJ-45 x 1, for network and DIGITAL LINK connections (HDBaseT
compatible, 100Base-TX, Art-Net compatible, HDCP 2.3 compatible, Deep Color compatible
RJ-45 x 1, for network connection, PJLink (class 2) compatible, 10Base-T/100Base-TX, Art-Net
compatible
High-density D-Sub 15 p (female) x 1
RGB signal
0.7 V [p-p] 75 Ω (SYNC ON GREEN: 1.0 V [p-p] 75 Ω)
SYNC/HD
VD
YP
P
signal Y: 1.0 V [p-p] including synchronization signal, P
B
R
High-density D-Sub 15 p (female) x 1
RGB signal
0.7 V [p-p] 75 Ω (SYNC ON GREEN: 1.0 V [p-p] 75 Ω)
SYNC/HD
VD
YP
P
signal Y: 1.0 V [p-p] including synchronization signal, P
B
R
M3 stereo mini jack x 1, 0.5 V [rms], input impedance 22 kΩ or more
D-Sub 9 p x 1, RS-232C compliant, for computer control
USB connector (type A) x 1, for connecting the optional Wireless Module (Model No.: AJ-WM50
Series), for connecting USB memory, for power supply (DC 5 V, maximum 2 A)
PT-FRQ60
36 dB
PT-FRQ50
35 dB
PT-FRQ60
31 dB
PT-FRQ50
28 dB
0 °C (32 °F) to 45 °C (113 °F)
*2*3*4
10 % to 80 % (no condensation)
[FLOOR/CEILING], [FRONT/REAR]
TTL high impedance, automatic positive/negative polarity
compatible
TTL high impedance, automatic positive/negative polarity
compatible
TTL high impedance, positive/negative polarity
TTL high impedance, positive/negative polarity
When [OPERATING MODE] is set to [NORMAL] or [ECO]
When [OPERATING MODE] is set to [QUIET]
compliant), PJLink (class 2)
TM
P
: 0.7 V [p-p] 75 Ω
B
R
P
: 0.7 V [p-p] 75 Ω
B
R
Advertisement
Table of Contents
