Table of Contents
Advertisement
Chapter 3 Basic Operations — Switching on/off the projector
6)
If the input signal is the analog RGB signal or the HDMI signal, press the <AUTO SETUP> button.
7)
Turn the zoom ring to adjust the size of the projected image to match the screen.
8)
Adjust the focus again with the focus ring.
9)
Adjust the zoom again with the zoom ring to adjust the size of the projected image to match the
screen.
Note
f When the projector is switched on for the first time after purchase, or when the [PROJECTOR SETUP] menu → [INITIALIZE] → [FACTORY
RESET] is executed, the [INITIAL SETTING] screen is displayed after the projection starts, followed by the [ADMINISTRATOR ACCOUNT]
screen. If the [PROJECTOR SETUP] menu → [INITIALIZE] → [NETWORK/E-MAIL ONLY] is executed, the [ADMINISTRATOR ACCOUNT]
screen is displayed after the projection starts. For details, refer to "When the initial setting screen is displayed" ( x page 44), "When the
administrator account setting screen is displayed" ( x page 49).
Switching off the projector
3)
1)
Press the power < v / b > button.
f The [POWER OFF(STANDBY)] confirmation screen is displayed.
2)
Press qw to select [OK], and press the <ENTER> button.
(Or press the power < v / b > button again.)
f Projection of the image will stop, and the power indicator <ON (G)/STANDBY (R)> on the projector body
lights orange. (The fan keeps running.)
3)
Wait for a few seconds until the power indicator <ON (G)/STANDBY (R)> of the projector body lights/
blinks red.
4)
Press the <OFF> side of the <MAIN POWER> switch to turn off the power.
Note
f For approximately five seconds after the projector is turned off, the indicator does not light up even if the power is turned on.
f Even when the power < v / b > button is pressed and the projector is switched off, the projector consumes power if the main power
of the projector is on.
When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], use of some functions is restricted,
but the power consumption during standby mode can be conserved.
f While projecting, the power can be turned off by pressing the <OFF> side of the <MAIN POWER> switch, or by directly using the breaker
under conditions where the <MAIN POWER> switch of the projector cannot be switched off/on easily such as while installing on the ceiling.
However, the settings or adjustments performed right before the power is turned off may not be reflected.
1)
4)
1)
2)
2)
ENGLISH - 51
Advertisement
Table of Contents
