Table of Contents
Advertisement
11) Press the <ENTER> button.
f The command is fixed and n is displayed at the left of the selected command.
f After the command is fixed, press the <MENU> button to close the detailed setting screen.
12) Press asqw to select [STORE], and press the <ENTER> button.
Note
f To delete a command that has been already set, press the <DEFAULT> button on the remote control while the screen in Step 5) is
displayed, or select [DELETE] at the screen in Step 6) and press the <ENTER> button.
f If multiple commands have been set for the same time, they are executed in chronological order starting from the smallest command
number.
f The operating time will be the local time. ( x page 116)
f If an operation is executed with the remote control or control panel of the projector or with a control command before the command set in
[SCHEDULE] is executed, the command set with the schedule function may not be executed.
[RS-232C]
Set the communication condition of the <SERIAL IN> terminal. Refer to "<SERIAL IN> terminal" ( x page 207).
1)
Press as to select [RS-232C].
2)
Press the <ENTER> button.
f The [RS-232C] screen is displayed.
3)
Press as to select [INPUT SELECT].
4)
Press qw to switch the item.
[PROJECTOR]
[DIGITAL LINK]
5)
Press as to select [BAUDRATE].
6)
Press qw to switch the item.
f The items will switch each time you press the button.
[9600]
[19200]
[38400]
7)
Press as to select [PARITY].
8)
Press qw to switch the item.
f The items will switch each time you press the button.
[NONE]
[EVEN]
[ODD]
Note
f When [INPUT SELECT] is set to [DIGITAL LINK], communication using that serial terminal is available only when the corresponding device
(such as the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G)) is connected to the <DIGITAL LINK/
LAN> terminal.
f When transferring logos via the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G), setting for "NO
SIGNAL SLEEP" of the DIGITAL LINK output supported device should be set to "OFF" to avoid interruption of communication.
f The input communication speed is fixed to 9 600 bps when [INPUT SELECT] is set to [DIGITAL LINK].
[FUNCTION BUTTON]
Set the function of the <FUNCTION> button on the remote control.
1)
Press as to select [FUNCTION BUTTON].
2)
Press the <ENTER> button.
f The [FUNCTION BUTTON] screen is displayed.
Chapter 4 Settings — [PROJECTOR SETUP] menu
Performs the RS-232C communication with the <SERIAL IN> terminal of the projector.
Performs the RS-232C communication via the optional DIGITAL LINK output supported device (Model
No.: ET-YFB100G, ET-YFB200G) and the <DIGITAL LINK/LAN> terminal.
Select the proper speed.
Select the parity condition.
ENGLISH - 119
Advertisement
Table of Contents
