[Status] - Panasonic PT-FRQ60WU7 Operating Instructions Manual

[STATUS]

Display the status of the projector.
1) Press as to select [STATUS].
2) Press the <ENTER> button.
f The [STATUS] screen is displayed.
3) Press qw to switch the pages.
f The page will change each time you press the button.
[PROJECTOR TYPE]
[SERIAL NUMBER]
[PROJECTOR RUNTIME]
[LIGHT RUNTIME]
[CONTINUOUS LIGHTING
TIME]
[MAIN/SUB VERSION]
[INTAKE AIR TEMP.]
[OPTICS MODULE TEMP.]
[EXHAUST AIR TEMP.]
[LIGHT TEMP. 1] *1
[LIGHT TEMP. 2]
*1
[SELF TEST]
[INPUT]
[SIGNAL NAME]
[MEMORY NO.]
[NUMBER OF REGISTERED
SIGNAL]
[COOLING CONDITION]
[ATMOSPHERIC PRESSURE] Displays the atmospheric pressure.
[ON COUNT]
[SIGNAL INFORMATION]
*1 The temperature status is indicated with text color (green/yellow/red) and bar scale. Use the projector within the range that the indication is
green.
r [DETAILED INFORMATION]
[INPUT]
[SIGNAL FORMAT]
[SIGNAL FREQUENCY]
[SYNC. STATE]
[V.SYNC WIDTH]
[SCAN TYPE]
[TOTAL DOTS]
[DISPLAY DOTS]
122 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Displays the projector type of the projector.
Displays the serial number of the projector.
Displays the runtime of the projector.
Displays the runtime of the light source.
Displays the elapsed time from when the light source is illuminated.
The elapsed time after the illumination of the light source can be confirmed when adjusting the focus.
The elapsed time is reset when the light source is temporarily turned off such as using the shutter
function.
Displays the main and sub versions of the firmware of the projector.
*1 Displays the status of the intake air temperature of the projector.
Displays the status of the internal temperature of the projector.
*1
*1 Displays the status of the exhaust air temperature of the projector.
Displays the temperature status for the front block of the light source (on the lens side).
Displays the temperature status for the rear block of the light source (on the exhaust vent side).
Displays the self-diagnosis information.
Displays the input terminal currently selected.
Displays the input signal name.
Displays the memory number of the input signal.
Displays the number of registered signals.
Displays the set cooling conditions.
[POWER ON TIMES]
[INPUT]
[SIGNAL FORMAT]
[SAMPLING]
[SIGNAL LEVEL]
[GAMMA]
[COLOR SPACE]
Displays the input terminal used for the projected image.
Displays the format of the input signal.
Displays the frequency of the input signal.
Displays the sync polarity of the input signal.
Displays the vertical sync signal pulse width of the input signal.
Displays the scan type of the input signal.
Displays the total dot count of the input signal.
Displays the number of input signal display dots.
Displays the number of times the power is turned on.
Displays the input terminal used for the projected image.
Displays the format of the input signal.
Displays the sampling information of the input signal.
Displays the signal level of the input signal.
Displays the [GAMMA] setting.
Displays the [COLOR SPACE] setting.