Table of Contents
Advertisement
Note
f It is recommended that images be projected continuously for at least 30 minutes before the focus is adjusted.
f Since the projected image size will change when the focus ring is turned, fine adjust the projected image size again by turning the zoom
ring.
f Perform the [POSITION] menu → [GEOMETRY] when the projected image is distorted.
Adjusting adjustable feet
Install the projector on a flat surface so that the front of the projector is parallel to the screen surface and the
projection screen is rectangular.
If the screen is tilted downward, extend the front adjustable feet so that the projected image becomes rectangular.
The adjustable feet can also be used to adjust the projector to be level when it is tilted in the horizontal direction.
Adjustable feet can be extended by turning them as shown in the figure. Turning them in the opposite direction will
return them to the original position.
Attention
f Be careful not to block the intake/exhaust vents with your hands or any objects when adjusting the adjustable feet while the light source is
on. ( x page 28)
Lens shift range
The projection position can be adjusted within the lens shift range based on the position of the projected image in
the standard projection position.
Following illustration indicates the lens shift range when the projector is installed on desk/floor.
Note
f Optimal image can be achieved by installing the projector squarely in front of the screen and adjusting the lens shift lever to center.
54 - ENGLISH
Chapter 3 Basic Operations — Projecting
Projected image width H
0.27 H
Standard projection position
Maximum adjustable range
Adjustable feet: 35 mm (1-3/8") each
0.34 H
Advertisement
Table of Contents
