Table of Contents
Advertisement
When [ASPECT] is set to [DEFAULT]
1)
Press as to select [ZOOM].
2)
Press the <执行> button.
f The [ZOOM] screen is displayed.
3)
Press as to select [MODE].
4)
Press qw to switch the item.
[INTERNAL]
[FULL]
5)
Press as to select [INTERLOCKED].
6)
Press qw to switch the item.
[OFF]
[ON]
7)
Press as to select [VERTICAL] or [HORIZONTAL].
f If [ON] is selected, select [BOTH].
8)
Press qw to adjust.
Note
f When the [POSITION] menu → [ASPECT] is set to anything other than [DEFAULT], [MODE] is not displayed.
[CLOCK PHASE]
You can adjust the image to achieve an optimal image when there is a flickering image or smeared outlines.
1)
Press as to select [CLOCK PHASE].
2)
Press qw or the <执行> button.
f The [CLOCK PHASE] individual adjustment screen is displayed.
3)
Press qw to adjust.
f Adjustment value will change between [0] and [+31]. Adjust the image so that the amount of interference is
at a minimum.
Note
f Adjustment may not be possible depending on the signal.
f There may be no optimal value if the output from the input computer is unstable.
f There may be no optimal value when the total dot number is shifted.
f [CLOCK PHASE] can be adjusted only when YC
terminal.
f [CLOCK PHASE] cannot be adjusted when a digital signal is input.
f The adjustment value will change to [0] when w is pressed while it was at [+31]. Also, the adjustment value will change to [+31] when q is
pressed while it was at [0].
[GEOMETRY]
You can correct various types of distortion in a projected image.
Unique image processing technology enables projection of a square image on a special screen shape.
The projected image can be made to look more natural by making topical correction as necessary.
1)
Press as to select [GEOMETRY].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[KEYSTONE]
Chapter 4 Settings — [POSITION] menu
Enlarges the size within the aspect range set with [SCREEN FORMAT].
Enlarges or reduces the size using the entire display area set with [SCREEN FORMAT].
Sets the [VERTICAL] and [HORIZONTAL] zoom ratio.
Uses [BOTH] to set zoom ratio. Image can be enlarged or reduced vertically and horizontally at the
same magnification.
C
/YP
P
signal or RGB signal is input to the <RGB 1 输入> terminal or the <RGB 2 输入>
B
R
B
R
Does not perform geometric adjustment.
Adjusts any trapezoidal distortion in the projected image.
ENGLISH - 87
Advertisement
Table of Contents
