Table of Contents
Advertisement
2)
Press the <ENTER> button.
f The [DATE AND TIME] screen is displayed.
3)
Press as to select [ADJUST CLOCK].
4)
Press the <ENTER> button.
f The [ADJUST CLOCK] screen is displayed.
5)
Press as to select an item, and press qw to set the local date and time.
6)
Press as to select [APPLY], and press the <ENTER> button.
f The setting of the date and time will be completed.
Note
f The replacement of the battery inside the projector is required when the time goes out of alignment right after correcting the time. Consult
your dealer.
Setting the date and time automatically
To set the date and time automatically, the projector must be connected to the network.
1)
Press as to select [DATE AND TIME].
2)
Press the <ENTER> button.
f The [DATE AND TIME] screen is displayed.
3)
Press as to select [ADJUST CLOCK].
4)
Press the <ENTER> button.
f The [ADJUST CLOCK] screen is displayed.
5)
Press as to select [NTP SYNCHRONIZATION], and press qw to change the setting to [ON].
6)
Press as to select [APPLY], and press the <ENTER> button.
f The setting of the date and time will be completed.
Note
f If synchronization with the NTP server fails just after [NTP SYNCHRONIZATION] is set to [ON], [NTP SYNCHRONIZATION] will return to
[OFF]. If [NTP SYNCHRONIZATION] is set to [ON] while the NTP server is not set, [NTP SYNCHRONIZATION] will return to [OFF].
f Access the projector via a web browser to set the NTP server. Refer to "[Adjust clock] page" ( x page 164) for details.
[SCHEDULE]
Set the command execution schedule for each day of the week.
Enabling/disabling the schedule function
1)
Press as to select [SCHEDULE].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
Note
f The [STANDBY MODE] setting will be forced to [NORMAL] when the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY
MODE] is set to [ECO], and [SCHEDULE] is set to [ON]. Changing the setting to [ECO] is not available. The [STANDBY MODE] setting will
not change back even when [SCHEDULE] is set to [OFF] in this condition.
How to assign a program
1)
Press as to select [SCHEDULE].
2)
Press qw to select [ON], and press the <ENTER> button.
f The [SCHEDULE] screen is displayed.
Chapter 4 Settings — [PROJECTOR SETUP] menu
Disables the schedule function.
Enables the schedule function. Refer to "How to assign a program" ( x page 117) or "How to set a
program" ( x page 118) for how to set the schedule.
ENGLISH - 117
Advertisement
Table of Contents
