Working basis
3.5 Locking the machine in place
Pic. 8: Locking the machine in place (1)
(1) - Arm shaft crank
(2) - Arresting groove
For some settings, the machine must be locked in place. To do this, the
locking pin (3) from accessory pack is inserted into a slot (2) on the arm
shaft crank (1), blocking arm shaft.
Pic. 9: Locking the machine in place (2)
(4) - Locking opening
Locking the machine in place
1. Remove the plug from the locking opening (4).
2. Turn the handwheel until the arresting groove (2) is in front of the lock-
3. Insert the locking pin (3) with end ø 5 mm into arresting groove (2).
Removing the lock
1. Pull the locking pin (3) out from arresting groove (2).
2. Insert the plug into the locking opening (4).
Service Instructions 52Xi, 52Xi-75 - 00.0 - 11/2021
①
ing opening (4).
②
③
(3) - Locking pin
④
17