Locking The Sewing Machine In Place - Dürkopp Adler 967 Service Instructions Manual

Working basis

3.6 Locking the sewing machine in place

For some settings, the machine has to be locked in place. To do this, the
locking peg from the accessory pack is inserted into a groove on the arm
shaft crank to block the arm shaft.
There are 2 securing positions:
• Position 1: Loop stroke position
• Position 2: Handwheel zero setting
Figure 12: Locking the sewing machine in place
(1) - Groove
(2) - Locking peg
Locking the machine in place
1. Turn the handwheel until the appropriate groove (1) is in front of the
2. Insert the locking peg (2) with the appropriate end in the groove (1).
Removing the lock
1. Pull the locking peg (2) out of the groove (1).
Service instructions 967 - 00.0 - 12/2014
• 5 mm end in the large groove
• Setting the loop stroke and needle bar height
• 3 mm end in the small groove
• Setting the handwheel position and checking the bottom dead
center for the needle bar
locking opening (3):
• Small groove at handwheel position 180°
• Large groove at handwheel position 200 - 205°
(3) - Locking opening
19