TEC B-372-QP Manual page 90

In the case of MaxiCode (two-dimensional code)

Format [ESC] XBaa; bbbb, cccc, d (, e) (, Jffgg) (, Zh) [LF] [NUL]
Term aa
bbbb
cccc
d
e
Jffgg
Zh
: Bar code number
00 to 31
: Print origin of X coordinate of the bar code
Fixed as 4 digits (in 0.1 mm units)
: Print origin of Y coordinate of the bar code
Fixed as 4 digits (in 0.1 mm units)
: Type of bar code
Z: MaxiCode (two-dimensional code)
: Mode selection (omissible)
0 to 9
* However, only modes 2, 3, 4 and 6 are supported.
(When a mode other than the above is designated, the designation is
corrected according to the below table.
Mode Mode actually processed
Omitted
Mode 0
Mode 1
Mode 2
Mode 3
Mode 4
Mode 5
Mode 6
Mode 7
Mode 8
Mode 9
: Connection setting
ff : Code number
gg : No. of divided codes
: Attachment of Zipper block and Contrast block
0 : No attachment of Zipper block and Contrast block
1 : Attachment of Zipper block and Contrast block
2 : Attachment of Zipper block
3 : Attachment of Contrast block
Mode 2
Mode 2
Mode 4
Mode 2
Mode 3
Mode 4
Mode 2
Mode 6
Mode 2
Mode 2
Mode 2
01 to 08
01 to 08
- 74 -