TEC B-372-QP Manual page 137

[Issue when using the stacker]
• When DIP SW 1-5 is turned OFF
(without the automatic forward feed standby):
Cut position
A
B
• When DIP SW 1-5 is turned ON (with the automatic forward feed standby):
Cut position
A
B
NOTE: When the stacker is used, the batch mode
with a cut interval of 1 is compulsory.
Head position
(1) Idling
(2) End of printing the 1st label (A)
A
(3) Feed to the cut position
A
(4) End of cutting the 1st label (A)
(5) Feed back to the home position
(6) End of printing the 2nd label (B)
B
(7) Feed to the cut position
B
(8) End of cutting the 2nd label (B)
(9) Feed back to the home position
Head position
(1) Idling (forward feed standby)
(2) Reverse feed to the home position
(3) End of printing the 1st label (A)
A
(4) Feed to the first position
A
(5) End of cutting the 1st label (A)
(6) Feed back to the home position
(7) End of printing the 2nd label
B
(8) Feed to the cut position
B
(9) End of cutting the 2nd label (B)
(10) Feed back to the home position
(11) 10-mm automatic forward feed
- 119 -
after 3 seconds.