Table of Contents
Advertisement
(4) Ribbon End
If the ribbon end sensor detects the ribbon end state in 5 mm continuously when the ribbon is
designated, an error will result.
If the ribbon end sensor detects the ribbon end state when the ribbon designation has been
selected, and an issue, feed and ejection is attempted when the printer stops, an error will
result.
(5)
Head Open Error
If the head open sensor detects the open state in 5 mm continuously, an error will result.
If the head open sensor detects the open state when an issue, feed and ejection is attempted
in the printer stop state, an error will result.
However, the feeding by the feed key on the printer and the issuing and feeding by the
expansion I/O are not included.
* When the pressure lever of the pinch roller is lowered on the B-872/672 (pressurization off
state), this state is regarded as a head open status.
(6)
Thermal Head Error
A broken dot error has occurred in the thermal head.
An error has occurred in the thermal head driver.
(7)
Thermal Head Temperature Abnormal
When the open-air temperature detection thermistor detects a high temperature, an error will
result.
When the thermal head temperature detection thermistor detects a high temperature, an error
will result.
(8)
Ribbon Error
When the ribbon rewind motor sensor and ribbon back tension motor sensor does not perform
detection if twice the prescribed time has passed, an error will result.
For the B-872/672, when the ribbon rewind motor sensor performs detection earlier than the
theoretical value within the prescribed time, an error will result.
• An abnormal condition has occurred in the sensor for determining the torque for the ribbon
motor.
• A ribbon jam has occurred.
• The ribbon has run out.
• The ribbon is not installed.
(9)
Rewinder Overflow
If the rewinder overflow sensor detects the overflow state in 5 mm continuously when the strip
function or the built-in rewinder is selected, an error will result.
If the overflow sensor detects an overflow state when an issue, feed or ejection is attempted
with the printer being stopped after the strip function or the built-in rewinder is selected, an
error will result.
(10) Stack Overflow
If there is too much stacked paper, the machine will stop as if it were paused.
* When the machine is restarted after the stack overflow, the machine enters the online mode
without feeding. A feed by the FEED key is not performed again after the machine is
restarted.
- 154 -
Advertisement
Table of Contents
