Table of Contents
Advertisement
6.5 PRINT DENSITY FINE ADJUST COMMAND
Function
Finely adjust the automatically set print density.
Format
[ESC] AY; abb, c [LF] [NUL]
Term
a
bb
c
Explanation
(1) If the print density fine adjustment value has been set in system mode (key
(2) The fine adjustment values in thermal transfer mode and direct thermal mode can
(3) The Print Density Fine Adjust Command is protected in memory (protected even if
(4) The fine adjustment value for both fine adjust command and system mode fine
(5) The max. value for each print speed is as follows. When the value exceeds the
Examples
To set the density in thermal transfer mode to +3, and the density in direct thermal mode
to -2.
10 PRINT #1, ESC$; "AY; +03, 0"; LF$; NUL$;
20 PRINT #1, ESC$; "AY; -02, 1"; LF$; NUL$;
:
Indicates whether to increase or decrease the density.
+ : Increase (darker)
- : Decrease (lighter)
:
Print density fine adjustment value
00 to 10 (in units of 1 step)
:
Indicates the mode for fine adjustment, thermal transfer or direct thermal.
0 : Thermal transfer
1 : Direct thermal
operation on the printer), the fine adjustment value will be the sum of the fine
adjustment by this command and the fine adjustment in system mode.
respective max. fine adjustment values each are ±10.
be set independently.
the power is turned off).
adjustment is 00 at shipment from the factory.
maximum, it is automatically corrected to the max. value, and then the printer
prints.
B-372/572
3"/sec
4"/sec
5"/sec
8"/sec
B-672/872
+10 step
–
–
+5 step
+2 step
- 33 -
[ESC] AY
The
Advertisement
Table of Contents
