TEC B-372-QP Manual page 176

9.1.3 Detail Status
LCD Message
ON LINE
HEAD OPEN
ON LINE
PAUSE
ON LINE
Display of error message
COMMUNICATION ERROR A parity error, overrun error or framing error
PAPER JAM
CUTTER ERROR
NO PAPER
NO RIBBON
HEAD OPEN
HEAD ERROR
EXCESS HEAD TEMP.
RIBBON ERROR
REWIND FULL
ON LINE
ON LINE
SAVE MODE ### %%%%
FLASH WRITE ERROR
FORMAT ERROR
FLASH MEMORY FULL
Display of error message
COMMUNICATION ERROR
DIVIDE ERROR
UNUSED CODE TRAP
POWER FAILURE
EEPROM ERROR
STACK OVERFLOW
STACKER ERROR
Printer Status
The head was closed with the head open.
The head was opened in on-line mode.
In operation (Analyzing command, drawing,
printing, feeding)
In pause
Waiting for stripping
A command error was found in analyzing the
command.
occurred during communication by RS-232C
A paper jam occurred during paper feed.
An abnormal condition occurred at the cutter.
The label has run out.
The ribbon has run out.
An attempt was made to feed or issue with
the head open.
(except the FEED key and expansion I/O)
A broken dot error has occurred in the
thermal head.
The thermal head temperature has become
excessively high.
An abnormal condition occurred in the sensor
for determining the torque for the ribbon
motor.
An overflow error has occurred in the
rewinder.
The label issue has terminated normally.
The feed has terminated normally.
In writable character or
PC command save mode
An error has occurred in writing the
flash memory.
An erase error has occurred in
formatting the flash memory.
Saving failed because of the
insufficient capacity of the flash
memory.
A command error has occurred in
analyzing the command.
A parity error, overrun error or
framing error has occurred during
communication by RS-232C.
A zero dividing error has occurred.
An undefined command was fetched.
A momentary power interruption has
occurred.
An EEPROM for back up cannot be
read/written properly.
There is too much stacked paper.
An attempt was made to issue when the
stacker was not turned ON.
- 157 -
Auto Status
Transmission
00
01
–
–
–
06
07
11
12
13
14
15
17
18
21
22
40
41
–
50
51
Writable
54
character,
PC command,
save mode
06
07
–
–
–
–
30
31
Detail Status
Status Request
Command
00
01
02
04
05
06
07
11
12
13
14
15
17
18
21
22
–
–
55
50
51
54
06
07
–
–
–
–
30
31