TEC B-372-QP Manual page 145


Transmissvie sensor (when using normal labels):
Feeding takes place according to the parameter designated by the Label Size
Set Command. However, the label-to-label gap is automatically sensed by the
reflective sensor and the stop position is finely adjusted.

Transmissive sensor (when using preprinted labels):
Feeding takes place according to the parameter designated by the Label Size
Set Command. However, the label-to-label gap is automatically sensed by the
transmissive sensor and the stop position is finely adjusted according to the
value set by the threshold set operation (key operation).

Reflective sensor (when using a manual threshold value)
Feeding takes place according to the parameters designated by the Label Size
Set Command. However, the black mark provided on the back of the tag
paper is automatically sensed by the reflective sensor and the paper position is
finely adjusted every piece, according to the set threshold setting value (set
using keys).
(2) Cut/non-cut
This option is valid in batch feed mode only. (Non-cut is selected in strip mode.)
If no subsequent command is received from the PC for 3 seconds after cut-feeding
when DIP SW1-5 is set to ON (with the automatic forward feed standby) in cut
mode, the printer automatically performs a 10-mm forward feed.
When the Feed Command is received in the forward feed standby state, the
printer performs a reverse feed to the original position.
* For notes, refer to the section regarding the Issue Command.
For cutting the label having label pitch of 38 mm or less, refer to the section
regarding the Position Fine Adjustment Command.
NOTE: If the stacker is used, the cut mode is compulsory.
(3) Feed mode
[Batch (non-cut)]
[Batch (cut)]
Cut position
Head position


Place paper.

End of feed.
(Complete feeding to the top of form and stop.)
Head position


Place paper.

End of feed. (Complete feeding to the top of form.)

Feed to the cut position.

Cut unnecessary paper.

Feed back to the home position.
- 127 -