TEC B-372-QP Manual page 134

Explanation (1) Number of labels to be issued



(2) Cut interval
The cut interval is valid only when the cutter has been installed and the issue mode
is "C". If an error occurs during an issue after the cut interval is designated, and
then printing is restarted, the printer ejects the printed paper then resumes printing
on the paper where the error occurred.
If no subsequent command is received from the PC for 3 seconds after cut-issuing
the last label, when the cut interval is valid and DIP SW 1-5 is set to ON (with the
automatic forward feed standby), the printer automatically performs a 10-mm
forward feed.
When the Issue Command is received during the automatic forward feed standby,
an issue is started after a reverse feed to the original position.
If another command is sent and then completed after sending the Issue
Command, the automatic forward feed is not performed.
completion, other commands should not be sent after the Issue Command has
been sent.
The power should not be turned off then on, or the printer should not be placed in
a pause/reset state before the automatic forward feed, since the automatic forward
feed is not performed when the paper is fed by turning the power off then on, or by
pressing the FEED key of the printer in the pause/reset state.
If the paper is fed by pressing the FEED key of the printer during the forward feed
standby, the printer feeds one label, cuts, performs the automatic forward feed
then stops.
NOTE: When the stacker is used, a cut interval equivalent to one label is
(3) Type of sensor




If increment/decrement is not specified, the designated number of pieces with
the same drawing dot will be issued.
If increment /decrement is specified, the designated number of pieces will be
issued while incrementing/decrementing the piece of the designated drawing
area.
* The increment/decrement designation is valid until the Image Buffer Clear
Command ([ESC] C) is transmitted.
compulsory.
No sensor: Printing takes place according to the parameter designated by the
Label Size Set Command.
Reflective sensor:
Printing takes place according to the parameter designated by the Label Size
Set Command. However, the black mark provided on the back side of the tag
paper is automatically sensed by the reflective sensor and the paper position is
finely adjusted every piece.
Transmissive sensor (when using normal labels):
Printing takes place according to the parameter designated by the Label Size
Set Command. However, the label-to-label gap is automatically sensed by the
reflective sensor and the paper position is finely adjusted every piece.
- 116 -
Therefore, before