TEC B-372-QP Manual page 35

5.2 LABEL ISSUE OPERATION
An example of the label issue operation is described below.
(1) Where the Save Data Call Command is not used:
Label Size Set Command
Image Buffer Clear Command
Bit Map Font Format Command
Outline Font Format Command
Bar Code Format Command
Bit Map Font Data Command
Outline Font Data Command
Bar Code Data Command
Yes
Yes
Yes
NOTES: (1) When placing new paper, the Label Size Set Command and Feed Command must
always be sent. When using the same paper after the power is turned off and then on,
the Label Size Set Command and Feed Command may be omitted.
(2) After the power is turned off and then on, the Bit Map Font, Outline Font, and Bar Code
Format Commands should be sent as occasion demands because they are not
protected in memory.
Power ON
Place paper
Position Fine
Adjust Command
Print Density Fine
Adjust Command
Feed Command
Line Format Command
Issue Command
<Change data issue>
No
<Format change>
No
<Label change>
No
Power OFF
[ESC] D: Set the label size.
[ESC] AX: Finely adjust the feed length, cut position,
and back feed length.
[ESC] AY: Finely adjust the print density.
[ESC] T: Feed one sheet of paper and align it with
the first printing position.
[ESC] C: Clear the image buffer.
[ESC] LC: Set the line format and draw.
[ESC] PC: Set the bit map font format.
[ESC] PV: Set the outline font format.
[ESC] XB: Set the bar code format.
[ESC] RC: Draw bit map font data.
[ESC] RV: Draw outline font data.
[ESC] RB: Draw bar code data.
[ESC] XS: Issue (print) the label.
- 19 -