Fitting And Adjustment - 3M PELTOR LiteCom Plus MT7H7 4410-EU Series Manual

GB
D. Explanation of the industrial safety helmet attachment table (table D)
1. Helmet manufacturer
2. Helmet model
3. Helmet attachment (figure D)
4. Head sizes: S = Small, M = Medium, L = Large
These ear-muffs should be fitted to, and used only with, the industrial safety helmets listed in the table.
For more information about 3M
3. COMPONENTS
3.1 Headband (figure E)
(E:1) Headband
(E:2) Headband padding (PVC foil)
(E:3) Headband wire (stainless steel)
(E:4) Two-point fastener (POM)
(E:5) Cushion (PVC foil and PUR foam)
(E:6) Foam liner (PUR foam)
(E:7) Cup
(E:8) Microphone for level dependent function for ambient listening
(E:9) Speech microphone (dynamic microphone)
(E:10) On/Off/Mode button
(E:11) + button
(E:12) – button
(E:13) Antenna
(E:14) Speech microphone input (J22)
(E:15) PTT (Push-To-Talk button) for built-in communication radio
(E:16) PTT auxiliary. (Push-To-Talk button) for externally connected equipment (E:17)
(E:17) External input/output (e.g. for external communication radio, external telephone)
(E:18) Lithium-ion battery (rechargeable)
3.2 Helmet attachment (figure F)
(F:1) Cup supporting arm (stainless steel)
3.3 Neckband (figure G)
(G:1) Neckband wire (stainless steel)
(G:2) Neckband cover (PO)

4. FITTING AND ADJUSTMENT

Headband
H:1 H:2
H:1 Slide out the cups and tilt the top of the cup out, as the cable must be on the outside of the headband.
H:2 Adjust the height of the cups by sliding them up or down while holding the headband in place.
H:3 The headband should be positioned across the top of your head.
Neckband
I:1 I:2
9
Safety Helmets, visit www.3M.com
TM
H:3
I:3