Fitting Instructions - 3M PELTOR PIC-100 NA User Instruction

The daily check procedure begins and can be observed by the
white channel light indicators (1) described below. The process
takes about 5 seconds.
LED indicators
All LEDs are blinking
white
All LEDs lit green
A = Green
B = Red
A
A = Red
B = Green
A
All LEDs lit Red
10.
Inspect the hearing protector before each use. If damaged, select
an undamaged hearing protector or avoid the noisy environment.
10.1. PREPARE THE EARPLUGS
Select the correct size of the eartip
The packaging includes 3 sizes of 3M™ UltraFit™ Communication
Eartips (small, medium and
Communication Eartips and 1 pair of 3M™ PELTOR™
CCC-GRM-25 Communication Eartips.
FP3881REVA_6sidedcover_32sidedinserts_4 x 6_2022-08-24.indd 7 FP3881REVA_6sidedcover_32sidedinserts_4 x 6_2022-08-24.indd 7
Description
Daily check is
running. White
lights blinking.
Daily check is
successful on
both left and right
earpieces.
Daily check
failure on left
earpiece. Red (B)
LEDs illuminate.
B
Daily check
failure on right
earpiece. Red (A)
LEDs illuminate.
B
Daily check
failure on both left
and right
earpieces. Red
LEDs illuminate.

FITTING INSTRUCTIONS

large), 1 pair of 3M™ Skull Screw™
3M™ UltraFit™ Communication Eartips
1. To choose the appropriate 3M™ UltraFit™ eartip size, begin
with the medium size.
2. Ensure that it is small enough to penetrate the ear canal and
What to do
provide a secure fit, but also large enough that at least one
flange seals the ear canal at the canal entrance.
No action
3. If the medium size does not provide a proper fit, proceed with
required.
the small or large size eartips as these were designed to fit
users for whom the medium size is not suitable.
3M™ Skull Screw™ Communication Eartips and
3M™ PELTOR™ CCC-GRM-25 Communication
Eartips
No action
required.
With the 3M™ Skull Screw™ and 3M™ PELTOR™ CCC-GRM-25
Microphones
Eartips, one size is intended to fit most.
are functioning
properly.
WARNING! Do not use product if the proper size and fit
Ensure the
cannot be obtained.
environment is
suitable to
conduct the
CAUTION: Use only 3M™ PELTOR™ Eartips designed for use
test, remove
with this product. Do not insert the earpiece directly into the ear
any debris from
without a correctly attached 3M™ PELTOR™ Eartip.
the earpiece
stem or from
around the
microphone
cover and
repeat daily
check.
Ensure the
environment is
suitable to
conduct the
test, remove
any debris from
the earpiece
stem or from
around the
microphone
cover and
repeat daily
Attaching the eartips
check.
NOTE: Make sure to handle the eartips with clean hands.
Ensure the
1. Push eartip onto the eartip stem.
environment is
suitable to
conduct the
test, remove
any debris from
the earpiece
stem or from
around the
microphone
cover and
repeat daily
check.
EN
7
2022-08-24 08:30:27 2022-08-24 08:30:27