Minolta 9000 Service Manual page 215

Switch Judgment
Sw. PV1
Should be ON by sliding PV lever.
Should be OFF by releasing PV lever.
Release shutter in "bulb" setting.
Should be ON when Ist shutter blade has
Sw.X run completely.
Should be OFF when 2nd shutter blade
has run completely.
% DO NOT SET DC-POWER-SUPPLY AT VOLTAGE MOI
damaged.
3. DC/DC converter
it with DC power supply.
'AF coupler slowly with finger :
Pointer of circuit tester should move.
RE THAN 12V: otherwise LED will be
Check voltage between printed wires
shown in the figure and GND. (Sw. 1 ON)
Vee2 13V
| _vooo av
Veo 1 BV
68