Minolta 9000 Service Manual page 212

65
2) Attach in-finder unit to body and tighten screws temporarily.
3) Align printed wire of LCD and flex PCB-A. (See fig. 4.)
Make sure that there is clearance @ between in-finder set and flex PCB-A.
4) Holding flex PCB-A on LCDs, cover pressure rubber (2072-5082-81). and place in-finder pressure
-A (2072-5074), -B (2072-5072). Holding the center of 5072 by finger, align printed wire of LCD
and flex PCB-A. Refer to 3).
'Make sure that 5072 has right angle (90°) or is not be deformed. (See fig. 5.)
Fig. 4 MFig. 5
®
(Restor)
3. Check that LCDs are ON
Install in-finder set onto body. Keeping Sw.0 ON, connect IC; @-@ and make sure that all
LCDs are ON.* (When all LCDs are ON, AF motor runs, but has no problem.)
Fig.7
To keep all LCDs ON, D Connect IC; @-@ w/ Sw.0 ON-----all LCDs ON @ Turn Sw.0
OFF----LCDs keep ON for 10 see @ When AF motor stops. disconnect IC; @-@------all
LCDs keep ON further © Turn Sw.0 ON to turn LCDs OFF.
'© Breakage of LCD:
© Disconnection of flex PCB-A--~
Replace LCD; (2071-4246.01)
Replace flex PCB-A (2071-0401)