Minolta 9000 Service Manual page 67

4. Push [1] or [2] key (2) and then [ENT] key.
(2: [11] key for previous 1C., [2] key for new IC.)
(below fig.)
{To ted figure :) <q@— | ——b> op tid figure 1 ae after
(Body No.) 190:
(Key to be pushed), 1D ty ve
1D tay 1
1 sey
3.2 All 4 screws for tripod socket are black. (below fig.)
%% 4 52 serews for tripod socket are white, or painted white. (below fig.)
Write screws, or pamted write
5. Set metering mode at AVERAGE.
6. Turn touch switch (or metering switch: ON.
1) Check links at AVERAGE in LCD of camera 1/0 tester.
2) Turn VRz to display [OK] in LCD of camera 1/0 tester.
3) Check if LCD on camera body displays [30] of shutter speed.
7. Set metering mode at SPOT. turn touch switch 'or metering switch) ON.
1) Check if links at SPOT in LCD of camera I/O tester.
2) Turn VRux_to display [OK] in LCD of camera 1/0 tester.
3) Check if LED on camera body displays [30] of shutter speed.
8. Set metering mode at H, check if [ K ] at H and [OK] display in LCD of camera 1/0 tester.
(If not, replace flexible PC
9. Set metering mode at S. check if [E] at S and [OK] display in LCD of camera 1/0 tester.
(If not, replace flexible PC board-A set with new one.)
Mig. 2
jard-A set with new one.)