Minolta 9000 Service Manual page 231

Description
Electric flash dimmer performance
1, Check by a luminance source L-2101 (If L-2101 is not available), check in the following
No. 2 methods.)
@Standard---The time counter display should be within the range of [ 0.6~1.7m:
'@ Checking procedures-Set up camera and measuring instruments as illustrated below to
read the time counter display when the shutter is released.
Be pe saa
}
Camera 'Time counter (TC-1)
Master lens :2072.0001.75) attached TRIG. slope A-CH : ~
Fil: Loaded BCH: +
Mode : A TRIG. level ACH: +1
180 : 100 BCH: +1
2. Checking by strobo tester (Model ST-
@Standard-Strobo tester display should be within the range of
Jet up 2 camera and measuring instruments as illustrated below. 30
seconds after the pilot l a m p of the electric flash lights up release
the shutter and read the di
Retiection caper (1.3m + 2m--for MINOLTA AEF series adjustment)
¢Camera '@ Strobe tester 'Electric flash
Installation master lens '2072.0001. MODE : NON. C Hi-Low changing
98Film : Loaded Sw.2 Hi
Mode : A
Iso : 100
% : Use Kedacolor VR (ISO 100) which has been exposed to light (indoor) at least one day.