Table of Contents
Advertisement
Transport and storage
4.1 General information
To transport the dispenser to the installation site with a forklift, proceed as follows:
1. Drive into the load carrier with the forks on the longitudinal side.
2. Drive in until the forks are protruding at the other side.
3. Lift the dispenser vertically. Pay attention to the center of gravity of the device and avoid
uneven surfaces.
4. Transport the dispenser to the site in an upright position.
Transporting the dispenser with a crane
Ensure adequate carrying capacity, depending on the hoisting gear used. Keep the angle of
inclination of 15 to 60° between the chain and the perpendicular at the attachment point. We
recommend, for example, a standard harness with 1 m sling chains of grade 8 or higher.
To transport the dispenser to the installation site with a crane, proceed as follows:
1. Attach the crane lugs to the four corners of the roof of the cabinet frame. Ensure the
following when using you own crane lugs:
– 25 to 30 mm long M12 thread
– Pay attention to the weight of the dispenser.
2. Hook the hoisting gear into the crane lugs.
3. Lift the dispenser vertically.
4. Transport the dispenser to the site with the dispenser suspended vertically.
30
DANGER
Tipping of the dispenser
The dispenser may tip if transported improperly. Tipping of the dispenser may result in
death or serious injury. Stay completely away from any hazardous areas.
Figure 4-2 Mounting the crane lugs
DANGER
Suspended load
Falling of the dispenser or any of its parts may result in death or serious injury. Stay
completely away from any hazardous areas.
Operating Instructions, 10/2023, A5E52758387-AB
Dispenser
Advertisement
Table of Contents
