Installing The Liquid Cooling Module - Dell EMC PowerEdge R750 Installation And Service Manual

NOTE: Ensure the anti-tilt wires on the liquid cooling module are in locked position when loosening the captive screws.
7. Set the anti-tilt wires on the liquid cooling module to the unlock position and lift the liquid module from the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 116. Removing the liquid cooling module
Next steps
1. If you are removing a faulty liquid cooling module,

Installing the liquid cooling module

Prerequisites
Never uninstall the heat sink from a processor unless you intend to replace the processor or system board. The heat sink is
necessary to maintain proper thermal conditions.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud
4. Remove the expansion card
5. If installed, remove the processor dust cover.
NOTE: The procedure to install the processor onto the liquid cooling module is same as installing the processor onto the
PHM.
NOTE: Ensure anti-tilt wires on the liquid cooling module are in the unlocked position.
116 Installing and removing system components
Safety instructions.
Before working inside your
or remove the GPU air shroud.
riser.
replace the liquid cooling
system.
modules, else remove the processor.