Installing The Gpu Riser Module - Dell EMC XC Core XC750xa Installation And Service Manual

Installing the GPU riser module

The procedure to install left and right GPU riser module are similar.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the air shroud.
4. Remove the cooling fan cage
5. Disconnect the GPU power and signal cables from the system board.
6. Disconnect R1 and R4 paddle cards
7. remove the rear mounting front PERC
8. If installed, remove the NVLink sponges.
Steps
1. Use both hands to hold the GPU riser module, align the holes on the GPU riser module with the guides on the system side
wall and base.
2. Lower the GPU riser module into system and press the touch points until the GPU riser module is firmly seated into the
system.
3. Rotate to close the GPU lift handle into the GPU riser module.
Figure 95. Installing the right GPU riser module
90 Installing and removing system components
Safety instructions.
Before working inside your
assembly.
from the system board.
module.
system.