Remote Management - ZyXEL Communications MES3500-24S User Manual

The following table describes the fields in this screen.
Table 185 Management > Access Control > Service Access Control
LABEL
Services
Active
Service Port
Timeout
Apply
Cancel

42.11 Remote Management

Click Management > Access Control > Remote Management to view the screen as shown next.
You can specify a group of one or more "trusted computers" from which an administrator may use a
service to manage the Switch. Click Access Control to return to the Access Control screen.
Figure 245 Management > Access Control > Remote Management
Chapter 42 Access Control
DESCRIPTION
Services you may use to access the Switch are listed here.
Select this option for the corresponding services that you want to allow to access the Switch.
For Telnet, SSH, FTP, HTTP or HTTPS services, you may change the default service port by typing the
new port number in the Server Port field. If you change the default port number then you will have
to let people (who wish to use the service) know the new port number for that service.
Type how many minutes (from 1 to 255) a management session can be left idle before the session
times out. After it times out you have to log in with your password again. Very long idle timeouts
may have security risks.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
MES3500-24S/MGS3520 Series User's Guide
368