Table of Contents
Advertisement
Chapter 36 Link Layer Discovery Protocol (LLDP)
Figure 193 Advanced Application > LLDP > LLDP-MED Configuration
The following table describes the labels in this screen.
Table 150 Advanced Application > LLDP > LLDP-MED Configuration
LABEL
DESCRIPTION
Port
This displays the Switch's port number. Select * to configure all ports simultaneously.
*
Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Notification
Topology
Select to enable LLDP-MED topology change traps on this port.
Change
MED TLV Setting
Location
Select to enable transmitting LLDP-MED location TLV.
Network Policy
Select to enable transmitting LLDP-MED Network Policy TLV.
Apply
Click Apply to save the changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
MES3500-24S/MGS3520 Series User's Guide
308
Advertisement
Table of Contents
Troubleshooting
