Ipv4 Static Route - ZyXEL Communications MES3500-24S User Manual

To enable IPv4 static route, configure the static route settings in the IP Application > Static Routing > IPv4
Static Route screen.

37.3 IPv4 Static Route

Click IP Application > Static Routing > IPv4 Static Route in the navigation panel to display the screen as
shown.
Figure 198 IP Application > Static Routing > IPv4 Static Route
The following table describes the related labels you use to create a static route.
Table 153 IP Application > Static Routing > IPv4 Static Route
LABEL
Active
Name
Destination IP
Address
IP Subnet Mask
Gateway IP
Address
Metric
Add
Cancel
Chapter 37 Static Route
DESCRIPTION
This field allows you to activate/deactivate this static route.
Enter a descriptive name (up to 10 printable ASCII characters) for identification purposes.
This parameter specifies the IP network address of the final destination.
Enter the subnet mask for this destination. Routing is always based on network number. If you
need to specify a route to a single host, use a subnet mask of 255.255.255.255 in the subnet
mask field to force the network number to be identical to the host ID.
Enter the IP address of the gateway. The gateway is an immediate neighbor of your Switch that
will forward the packet to the destination. The gateway must be a router on the same segment
as your Switch.
The metric represents the "cost" of transmission for routing purposes. IP routing uses hop count
as the measurement of cost, with a minimum of 1 for directly connected networks. Enter a
number that approximates the cost for this link. The number need not be precise, but it must be
between 1 and 15. In practice, 2 or 3 is usually a good number.
Click Add to insert a new static route to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to reset the above fields to your previous configuration.
MES3500-24S/MGS3520 Series User's Guide
314