Viewing And Editing Policy Configuration - ZyXEL Communications MES3500-24S User Manual

Table 74 Advanced Application > Policy Rule (continued)
LABEL
Egress Port
Priority
DSCP
TOS
Rate Limit
Bandwidth
Action
Specify the action(s) the Switch takes on the associated classified traffic flow.
Forwarding
Priority
Diffserv
Outgoing
Rate Limit
Add
Cancel
Clear

22.3 Viewing and Editing Policy Configuration

To view a summary of the classifier configuration, scroll down to the summary table at the bottom of the
Policy screen. To change the settings of a rule, click a number in the Index field.
Figure 107 Advanced Application > Policy Rule: Summary Table
Chapter 22 Policy Rule
DESCRIPTION
Type the number of an outgoing port.
Specify a priority level.
Specify a DSCP (DiffServ Code Point) number between 0 and 63.
Specify the type of service (TOS) priority level.
You can configure the desired bandwidth available to a traffic flow.
Specify the bandwidth in kilobit per second (Kbps). Enter a number between 1 and 1000000.
Select No change to forward the packets.
Select Discard the packet to drop the packets.
Select Do not drop the matching frame previously marked for dropping to retain the frames that
were marked to be dropped before.
Select No change to keep the priority setting of the frames.
Select Set the packet's 802.1p priority and send the packet to priority queue to replace the
packet's 802.1p priority field with the value you set in the Priority field. Then put the packets in the
designated queue.
Select No change to keep the TOS and/or DSCP fields in the packets.
Select Set the packet's TOS field to set the TOS field with the value you configure in the TOS field.
Select Set the Diffserv Codepoint field in the frame to set the DSCP field with the value you
configure in the DSCP field.
Select Send the packet to the egress port to send the packet to the egress port.
Select Enable to activate bandwidth limitation on the traffic flow(s).
Click Add to insert the entry in the summary table below and save your changes to the Switch's
run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save
link on the top navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click Cancel to begin configuring this screen afresh.
Click Clear to set the above fields back to the factory defaults.
MES3500-24S/MGS3520 Series User's Guide
186