ZyXEL Communications VPN Series Handbook page 795

www.zyxel.com
Only the USG needs to be configured. You do not need to change any settings on the
switch.
On the USG, go to Configuration > Network > Interface > LAG.
Choose the proper interface type and zone depending on the case. Also, select the
slave ports that will be added in the LAG interface.
Link Monitoring: Mii monitoring monitors the state of the local interface.
Updelay is the time to wait to enable the slave port after the device detects the link
recovery.
Downdelay is the time to wait to disable the slave port after the device detects the link
failure.
802.3ad (LACP) Mode:
(Both devices need to be configured. Only one switch can be used. The port speed
and duplex must be the same.)
795/810