Table of Contents
Advertisement
How to Setup and send logs to a Syslog Server
This example shows how to set up the syslog server profiles to mail ZyWALL/USG log
messages to the specific destinations. You can also specify which log messages to
syslog server. When the syslog server is configured, you will receive the real time system
logs.
ZyWALL/USG Setup and Configure sending logs to a syslog and Vantage Reports
Server
Note: All network IP addresses and subnet masks are used as examples in this
article. Please replace them with your actual network IP addresses and subnet
masks. This example was tested using USG110 (Firmware Version: ZLD 4.25).
Set Up the Syslog Server (Use Papertrail syslog in this example)
Register an account on Papertrail:
https://papertrailapp.com
www.zyxel.com
452/810
Advertisement
Table of Contents
