Advertisement
Code
Contents
9140
Sensor error in coin vender
change (Yen 100)
Change is empty despite
change is enough.
9150
Sensor error in coin vender
change (Yen 500)
Change is empty despite
change is enough.
9160
Coin vender pay-out error
Coin is paid out despite the
pay-out motor is determined
not active.
9170
Coin vender pay-out sensor
error
Coin is paid out despite the
pay-out motor is determined
not active.
9500
ISC PWB error A
ISC PWB error B
9510
Y116141-8
Causes
Coin jam in the
Check visually and remedy.
change tube
Poor contact in the
Check if the change empty sensor is intact.
connector.
Defective change
Replace the coin mec.
empty sensor.
Defective coin
vender control
PWB.
Coin jam in the
Check visually and remedy.
change tube
Poor contact in the
Check if the change empty sensor is intact.
connector.
Defective change
Replace the coin mec.
empty sensor.
Defective coin
vender control
PWB.
Defective pay-out
Replace the coin mec.
motor.
Change jam at the
Check visually and remedy.
pay-out.
Defective pay-out
Replace the coin mec.
motor.
Defective pay-out
sensor.
Main PWB
ISC PWB
Main PWB
DP SHD PWB
1-4-71
Check procedures/
corrective measures
1. Reinsert the connector if its connection
is loose.
Main PWB (YC25) and ISC PWB (YC4)
2. Replace the main PWB (see page 1-5-
31).
3. Replace the ISC PWB
4. Contact the Service Support.
1. Reinsert the connector if its connection
is loose.
DP relay PWB (YC2) and DP SHD PWB
(YC3)
2. Replace the main PWB (see page 1-5-
31).
3. Replace the DP SHD PWB.
4. Contact the Service Support.
2NP
Service Manual
Advertisement
