Advertisement
Item No.
U161
Setting the fuser control temperature
Description
Changes the fuser control temperature and control temperature correction value and other set
values.
Purpose
Normally no change is necessary. However, this mode can be used to prevent curling or creasing
of paper, or solve a fuser problem on thick paper.
Setting
1. Press the start key.
2. Select the item to be set.
3. Change the setting value using the +/- keys or numeric keys.
Copy Curb(Edge)
Curb(Edge)
Return(Edge)
Ready(Edge)
Pressure(Press)
High speed(Center)
Ready(Center)
Drive(Center)
Full speed(Center)
Wait(Center)
WarmUp Curb(Center)
Curb(Center)
Low power(Center)
Ready(Press)
Curb(Press)
Wait Offset(Press)
4. Press the start key. The value is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Service Manual
Display
Prevention temperature of overtem-
perature rise under copy
Prevention temperature of overtem-
perature rise
Return temperature of overtempera-
ture rise
Ready display temperature
Pressurizing beginning temperature
Full speed shift temperature
Ready display temperature
The second stability temperature
Print control temperature
Control temperature when being
standing by
Electric power control temperature at
start-up
Prevention temperature of overtem-
perature rise
Low electric power control
temperature
Ready display temperature
Prevention temperature of overtem-
perature rise
Correction temperature when being
standing by
Description
Description
1-3-82
2NP
Setting
Initial
range
setting
100 to 250
210
100 to 250
240
100 to 250
190
0 to 200
110
0 to 200
100
0 to 200
125
100 to 200
150
100 to 200
155
100 to 200
155
100 to 200
130
0 to 200
150
170 to 250
240
0 to 200
90
0 to 200
50
170 to 250
200
0 to 200
95
Y116141-8
Advertisement
