Advertisement
Item No.
U201
8. After completing the setting, "Initialize
Completed." is displayed and entering
Check mode.
Method: [Check
Single Tap Check
1. Press the start key.
2. Press the center of three "+" signs and
confirm the display positions.
* : Press it using a tool with a fine tip
(touch panel pen etc).
3. Make sure that the gap from coordi-
nates X and Y is 6 or less, respectively.
* : If the setting values are not aligned,
select "Initialize" and press the Start
key to revert to step 1.
Service Manual
Description
Initialize completed.
Initialize
Single Tap Check.
Press the center of the "+" sign.
* Press it using a tool with a fine tip.
If you need to perform initialization again, select "Initialize" and press the Start key.
+
Initialize
Multi Tap
Check
Single Tap Check.
Select "Multi Tap Check" and press the Start key to go to the next step.
If you need to perform initialization again, select "Initialize" and press the Start key.
+
(-2,0)
Figure 1-3-27
1-3-88
Figure 1-3-25
+
+
Figure 1-3-26
+
(-1,2)
+
Y116141-8
2NP
(1,0)
Advertisement
