Lexmark XM3250 Service Manual page 120

Ejector jam service check
Action
Step 1
a
Remove the stapler service cover. See
removal" on page
b
Reseat the stapler paddle HP sensor cable from the stapler
controller board.
c
Restart the printer.
Does the problem remain?
Step 2
Swap the sensor (stapler paddle HP) and sensor (stapler right
tamper HP).
Does the same error occur?
Step 3
a
Reseat the cable from the motor (stapler paddle).
b
Reseat the motor cable from the stapler controller board.
Does the problem remain?
Step 4
Replace the motor. See
page 337.
Does the problem remain?
Step 5
Reseat the stapler interface cable from the stapler controller board,
and then restart the printer.
Does the problem remain?
Step 6
Check the interface cable for damage.
Is the interface cable free of damage?
Step 7
Replace the interface cable. See
removal" on page 347.
Does the problem remain?
"Stapler service cover
341.
"Motor (stapler paddle) removal" on
"Stapler interface cable
Diagnostics and troubleshooting
Yes
Go to step 2.
Go to step 3.
Go to step 4.
Go to step 5.
Go to step 6.
Go to step 8.
Go to step 8.
120
7018
No
The problem is
solved.
If a 424.xx error
occurs, then replace
the affected sensor.
See "Sensor (stapler
right tamper HP)
removal" on
page 366.
The problem is
solved.
The problem is
solved.
The problem is
solved.
Go to step 7.
The problem is
solved.