Table of Contents
Advertisement
Cleaning
Note:
Improper wash-down procedures may
negatively affect bearing life. Do not wash down
the machine when it is still hot and avoid directing
high-pressure or high-volume spray at the bearings.
Cleaning Under the Mower
Deck Belt Cover
Service Interval: Before each use or daily
1.
Disengage the blade-control switch (PTO) and
engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Insert an air nozzle in the gap between the
belt cover and the top of the mower deck. Use
compressed air to clear any accumulated grass
from under the mower deck belt cover.
Cleaning Under the Mower
Deck
Service Interval: Before each use or daily
1.
Disengage the blade-control switch (PTO) and
engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Prepare the mower deck for maintenance;
refer to
Rotating the Mower Deck into the
Maintenance Position (page
4.
Remove any packed grass or debris, and clean
as necessary.
71).
85
Cleaning the Hopper
Screen
Service Interval: Before each use or daily
1.
Open the hopper door.
2.
Pull the release lever on the bottom of the
hopper screen downward
Figure 138
1. Release lever
3.
Remove the hopper screen and clean it
139).
Figure 139
4.
Install the hopper screen.
(Figure
138).
g217355
2. Hopper screen
(Figure
g215931
Advertisement
Table of Contents
