Maintenance; Recommended Maintenance Schedule(S) - Toro 31051 Operator's Manual

Maintenance

Note:
Download a free copy of the electrical or hydraulic schematic by visiting
for your machine from the M
Important:
Refer to your engine owner's manual for additional maintenance procedures.
CAUTION
If you leave the key in the switch, someone could accidently start the engine and seriously
injure you or other bystanders.
Remove the key from the switch before you perform any maintenance.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first hour
After the first 10 hours
After the first 50 hours
After the first 500 hours
Before each use or daily
Every 25 hours
Every 50 hours
Every 100 hours
link on the home page.
ANUALS
Maintenance Procedure
• Torque the wheel lug nuts.
• Torque the wheel lug nuts.
• Check and adjust the service brakes.
• Check the tension of the alternator belt.
• Check the tension of the PTO belt.
• Change the engine oil and engine-oil filter.
• Check and adjust the service brakes.
• Check the tension of the PTO belt.
• Change the oil in the mower-deck gearbox.
• Check the mower deck belt tension.
• Replace the hydraulic fluid.
• Check the air pressure in the tires.
• Check the engine cranking safety-interlock system.
• Check the shut-off safety-interlock system.
• Check PTO safety-interlock system.
• Check the back-up alarm safety-interlock system.
• Check the engine-oil level.
• Check the cooling system and the coolant level.
• Check the radiator screen and radiator for debris.
• Check the hydraulic-fluid level.
• Inspect the blades.
• Clean under the mower deck belt cover.
• Clean the mower deck.
• Clean the hopper screen.
• Clean the rear slots in the hopper door.
• Check the electrolyte level. (If the machine is in storage, check it every 30 days.)
• Grease the mower deck.
• Grease the bearings and bushings.
• Remove the air-cleaner cover and clean out the debris. Do not remove the filter.
• Drain water from the fuel/water separator.
• Check the mower deck belt tension.
• Lubricate the driveshaft sliding joint.
• Replace the air filter. Replace the air-filter element sooner if dirty or damaged.
• Replace the air-cleaner filter More frequently in extreme dusty or dirty conditions.
39
www.Toro.com and searching