Table of Contents
Advertisement
Pre-Maintenance
Procedures
Maintenance Safety
•
Before you leave the operator's position, do the
following:
– Park the machine on a level surface.
– Disengage the power takeoff and lower the
attachments.
– Engage the parking brake.
– Shut off the engine and remove the key.
– Wait for all movement to stop.
•
Allow machine components to cool before
performing maintenance.
•
If the cutting units are in the transport position, use
the positive mechanical lock (if equipped) before
you leave the machine unattended.
•
If possible, do not perform maintenance while the
engine is running. Keep away from moving parts.
•
Support the machine with jack stands whenever
you work under the machine.
•
Carefully release pressure from components with
stored energy.
•
Keep all parts of the machine in good working
condition and all hardware tightened, especially
blade-attachment hardware.
•
Replace all worn or damaged decals.
•
To ensure safe, optimal performance of the
machine, use only genuine Toro replacement
parts. Replacement parts made by other
manufacturers could be dangerous, and such use
could void the product warranty.
Securing the Hopper in the
Raised Position
1.
Park the machine on a level surface.
2.
Raise the hopper to the fully raised position;
refer to
Raising the Hopper (page
3.
Secure the hopper by performing the following:
A.
Push the pin on magnetic safety lock inward
(Figure
41).
B.
While still holding the pin in, lower magnetic
safety lock onto the hydraulic cylinder
(Figure
41).
C.
Repeat steps
42
30).
A
and
B
on the other side.
Figure 41
g215390
Advertisement
Table of Contents
