Table of Contents
Advertisement
2.
Disengage the PTO, lower the mower deck, and
engage the parking brake.
3.
Shut off the engine and remove the key.
4.
Remove the roller shaft, bolt, and nut securing
the roller to the deck bracket
Figure 30
1. Nut
2. Roller shaft
5.
Align the roller with the appropriate holes and
install the shaft with the bolt and nut
Figure 31
1. Nut
2. Roller shaft
(Figure
30).
g215276
3. Bolt
4. Roller
(Figure
31).
g215277
3. Bolt
4. Roller
Adjusting the Rear
Anti-Scalp Rollers
Mount the rollers so that there is a 19 mm (3/4 inch)
clearance from the ground.
1.
Park the machine on a level surface.
2.
Disengage the PTO, lower the mower deck, and
engage the parking brake.
3.
Shut off the engine and remove the key.
4.
Remove the lock pin from the roller pin
32).
1. Roller pin
5.
Move the roller pin up or down to the desired
position and secure it with the lock pin
32).
6.
Repeat steps
ensure that it matches the other setting.
Resetting the PTO Function
Note:
If you leave the operator's seat while the
PTO switch is in the O
automatically shut off the engine.
Perform the following to reset the PTO function:
1.
Push in the PTO switch knob.
2.
Rotate the key to the O
3.
Rotate the key to the O
start the engine.
4.
Pull out the PTO switch knob.
34
Figure 32
2. Lock pin
4
and
5
on the other side and
position, the machine will
N
position.
FF
/P
position, then
N
REHEAT
(Figure
g215336
(Figure
Advertisement
Table of Contents
