Table of Contents
Advertisement
Setup
Media and Additional Parts
Description
Operator's Manual
Engine owner's manual
Declaration of Conformity
Note:
Determine the left and right sides of the machine from the normal operating position.
1
Charging the Battery
No Parts Required
Procedure
1.
Connect a 3 to 4 A battery charger to the battery
posts. Charge the battery at a rate of 3 to 4
A until the specific gravity of the electrolyte
is 1.250 or higher and the temperature of the
battery is at least 16°C (60°F), with all cells
freely discharging gas.
2.
When the battery is charged, disconnect the
charger from the electrical outlet and then
disconnect the charger from the battery posts.
Note:
Incomplete charging may result in
gassing of the battery and the overflow of battery
acid, causing corrosive damage to the machine.
2
Checking the Fluid Levels
No Parts Required
Procedure
•
Check the engine-oil level before you start the
engine; refer to
Checking the Engine-Oil Level
(page
51).
•
Check the coolant level before you start the
engine; refer to
Checking the Cooling System and
Coolant Level (page
•
Check the level of the hydraulic-fluid level before
you start the engine; refer to
Hydraulic-Fluid Level (page
62).
Checking the
70).
Qty.
1
Review before operating the machine.
1
Use to reference engine information.
1
3
Checking the Air Pressure
in the Tires
No Parts Required
Procedure
Front and rear tires air pressure specification: 140
kPa (20 psi).
Caster tires air pressure specification: 150 kPa
(21 psi).
Check the air pressure in the front and rear tires
before the engine is first started.
Note:
The tires may be over-inflated or under-inflated
for shipping; therefore, you may have to adjust the
air pressure in the tires.
11
Use
Figure 3
g001055
Advertisement
Table of Contents
