Table of Contents
Advertisement
Figure 74
1. Feeler gauge
•
If the gap is less than 0.25 mm (0.01
inch), then install the shim; refer to
Troubleshooting (page
•
If the gap is sufficient, proceed to the
safety check in step F.
F.
Perform the following safety check:
i.
Sit on the seat and start the engine.
ii.
Make sure that the blades do not
engage with the blade-control switch
(PTO) in the O
the clutch is disengaged.
If the clutch does not disengage,
install the shim again; refer to
Troubleshooting (page
iii.
Engage and disengage the
blade-control switch (PTO) 10
consecutive times to ensure that the
clutch is functioning properly.
g010873
71).
position, and that
FF
71).
Cooling System
Maintenance
Cleaning the Engine Screen
and Engine-Oil Cooler
Service Interval: Before each use or daily
Remove any buildup of grass, dirt, or other debris
from the oil cooler
(Figure
Remove any buildup of grass, dirt, or other debris
from the engine screen. This helps ensure adequate
cooling and correct engine speed and reduces the
possibility of overheating and mechanical damage to
the engine
(Figure
75).
53
75).
Figure 75
g029644
g009191
Advertisement
Table of Contents
