Lubricating The Driveshaft U-Joints - Toro 31051 Operator's Manual

Lubricating the Driveshaft
U-Joints
Service Interval: Every 200 hours—Lubricate the
driveshaft U-joints.
Grease specification: No. 2 lithium grease
Important:
Dusty and dirty operating conditions
could cause dirt to get into the bearings and
bushings, resulting in accelerated wear.
Note:
Lubricate the grease fittings immediately after
every washing, regardless of interval specified.
1. Wipe grease fitting clean so debris is not forced
into the bearing or bushing.
2. Pump grease into the bearing or bushing.
3. Wipe off excess grease.
•
Forward U-joint of the driveshaft at the mower
gearbox (Figure 52).
Figure 52
•
Rear U-joint of the driveshaft at the PTO
53).
g236049
g235948
(Figure
47
Figure 53
g236052
g235952