Table of Contents
Advertisement
Operating Tips
•
Practice driving before operating the machine,
because it has a hydrostatic transmission
and its characteristics are different than some
turf-maintenance machines.
•
To maintain enough power for the machine and
deck while mowing, regulate the traction pedal to
keep the engine speed (rpm) high and constant.
Decrease the ground speed as the load on the
cutting blades increases; increase the ground
speed as the load on the blades decreases. This
allows the engine, working with the transmission, to
sense the proper ground speed while maintaining
a high blade-tip speed necessary for good quality
of cut. Therefore, allow the traction pedal to move
upward as the engine speed decreases, and press
pedal slowly as the speed increases. When driving
from 1 work area to another (with no load and the
deck raised), have throttle in the F
press the traction pedal slowly but fully to attain
the maximum ground speed.
•
Before shutting off the engine, move all controls to
the N
position and move the throttle to the
EUTRAL
S
position. Rotate the key switch to the O
LOW
position to shut off the engine.
•
The engine does not run when the engine coolant
is in over-temperature condition. Let the engine
and cooling system cool, and check the cooling
system; refer to
Checking the Cooling System and
Coolant Level (page
•
It is important to carry socket wrench with a 100
mm extension and 17 mm socket while operating
the machine. Use the socket wrench to open
the bypass valve if you need to push or tow the
machine.
position and
AST
62).
After Operation
General Safety
•
Shut off the engine, remove the key, and wait
for all movement to stop before you leave the
operator's position, Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
•
Clean grass and debris from the cutting units,
mufflers, and engine compartment to help prevent
fires. Clean up oil or fuel spills.
•
If the cutting units are in the transport position, use
the positive mechanical lock (if available) before
you leave the machine unattended.
•
Allow the engine to cool before storing the machine
in any enclosure.
•
Remove the key and shut off the fuel (if equipped)
before storing or hauling the machine.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
FF
•
Maintain and clean the seat belt(s) as necessary
Pushing or Towing the
Machine
Operator provided tool: a socket wrench with a 17
mm socket and 100 mm extension.
In case of an emergency, you can tow the machine
a very short distance. However, Toro does not
recommend this as standard procedure.
Important:
Pushing or towing the machine faster
than 3 to 5 km/h (2 to 3 mph) may damage the
transmission. If you must move the machine a
long distance, transport it on a truck or trailer.
Whenever you push or tow the machine, open the
bypass valve.
35
Advertisement
Table of Contents
