Table of Contents
Advertisement
Adjusting the Height-of-Cut
Pointer
1.
With the mower blades aligned front to back and
the front of the blades adjusted to 75 mm (3
inches) from the ground, check the position of
the height-of-cut indicator.
2.
Sit in the operator's seat and look at the pointer
of the height-of-cut indicator
Figure 130
1. Height-of-cut indicator (75 mm position)
3.
If the pointer of the height-of-cut indicator is not
aligned to 75 mm mark, perform the following:
A.
Loosen the 2 jam nuts that secure the
height-of-cut link
Figure 131
1. Pointer (height-of-cut
indicator)
2. Jam nuts
B.
Rotate the link until the pointer of the
height-of-cut indicator is aligned to 75 mm
mark when viewed from the operator's seat
(Figure 130
C.
Tighten the 2 jam nuts
(Figure
130).
(Figure
131).
3. Height-of-cut link
and
Figure
131).
(Figure
131).
Checking the Mower Deck
Belt Tension
Service Interval: After the first 50 hours
Every 50 hours
1.
Park the machine on a level surface.
2.
Disengage the PTO, lower the mower deck, and
engage the parking brake.
3.
Shut off the engine and remove the key.
4.
Loosen or tighten the jam nut until the tension
indicator arrow aligns with the outer surface of
the washer
g231943
1. Tension indicator arrow
2. Belt-tensioning spring
Replacing the Mower Deck
Belt
Removing the Mower Belt
1.
Park the machine on a level surface, disengage
the PTO, and lower the mower deck.
2.
Engage the parking brake, shut off the engine,
and remove the key.
3.
Remove the belt cover and pulley cover; refer
g231994
to
Removing the Belt Cover (page 77)
Removing the Pulley Cover (page
4.
Loosen the jam nut of the belt tensioner until you
can slip the belt off the belt-tensioning pulley
(Figure
133).
82
(Figure
132).
Figure 132
3. Washer
4. Jam nut
g216382
and
77).
Advertisement
Table of Contents
