Attachments/Accessories; Before Operation; Performing Daily Maintenance; Checking The Tire Air Pressure - Toro Groundsmaster e3200 Operator's Manual

Electrical Specifications Table
Battery Quantity
Rated Voltage
Amp Hours

Attachments/Accessories

A selection of Toro approved attachments and accessories is available for use with the machine to enhance
and expand its capabilities. Contact your Authorized Service Dealer or authorized Toro distributor or go to
www.Toro.com for a list of all approved attachments and accessories.
To ensure optimum performance, use only genuine Toro replacement parts and accessories. Replacement
parts and accessories made by other manufacturers could be dangerous, and such use could void the
product warranty.
Operation

Before Operation

Performing Daily
Maintenance
Before starting the machine each day, perform the
Each Use/Daily procedures listed in
(page 42).
Checking the Tire Air
Pressure
Service Interval: Before each use or daily
Tire air pressure specification:
•
Front tires: 138 kPa (20 psi)
•
Rear tires: 193 kPa (28 psi)
DANGER
Low tire pressure decreases machine side-hill
stability. This could cause a rollover, which
may result in personal injury or death.
Do not underinflate the tires.
Check the air pressure in the front and rear tires. Add
or remove air as needed to set the air pressure in the
tires to the tire air pressure specification.
Important:
Maintain pressure in all tires to
ensure a good quality of cut and proper machine
performance.
11 (standard with the machine; can be equipped with 13, 15 or 17)
61.5 VDC maximum and 55.3 VDC nominal usage
439.6 (11 batteries)
519.6 (13 batteries)
599.6 (15 batteries)
679.5 (17 batteries)
Check the air pressure in all the tires before
operating the machine.
Maintenance
Checking the
Safety-Interlock System
Service Interval: Before each use or daily
The purpose of the safety-interlock system is to
prevent the machine from starting unless the traction
pedal is in neutral and the PTO switch is in the O
position. In addition, the machine should stop when
the following occurs:
•
•
29
Figure 21
The PTO switch is set to the O
are not in the seat.
The traction pedal is pressed but you are not in
the seat.
g001055
FF
position and you
N